1. Product Introduction
This machine adopts the technology of double-drive
double-roller-extruding, and the product is formed once after
sizing, material feeding, spreading no-woven cloth, compounding and
repressing. The equipment runs stablely with high automatization
degree, and the specification of its product can be adjusted
arbitrarily. The equipment actually realizes the industrial
production-line of new model building wall board, and the product
have even and glazed surface with high compactness. The equipment
largely reduces the labor intensity of worker and thoroughly
changes many shortages of the former casting forming with upright
mould or flat mould, such as large mould usage, low recycling rate,
required electrical heating or steam heating, single kind of
product as well as the sound insulation and heat-preserving which
don’t meet the market requirements.
2. Raw material and cost analysis
The wheat straw board is made of filling materials, such as sawdust
and all kinds of crushed plant straw (you can select any one kind ) and several chemical raw materials
which are token as modified material after special technology. The board has such features: quickly
hard, high strength, large format, fireproofing, dampproof and good waterproof performance. It can be
nailed, planed and sticked. The machine can be adjusted arbitrarily, and then produce the board
with the thickness of 2-60mm, the biggest width of 1, 300mm and unlimited length. So you
can adjust the thickness of board at will.
| Names of materials | Each dosage |
| Magnesium | 2.978yuan |
| Magnesium chloride | 1.23yuan |
| Non-wovens | 0.85yuan |
| Glass cloth | 1.05yuan |
| Perlite | 0.62yuan |
| Sawdust | 0.647yuan |
Take 1200mm*2400mm*8mm Glass magnesium board an example in china.
3. Technology features
There is not any requirement about high temperature and high
pressure during production processing. The board will be formed at
one time after roller-extruding
under the conditions of normal temperature and normal pressure.
This is a green environmental-protection project, because that
there is no waste water, waste
materials and waste gas during its production processing. The
finished board
don’t need high temperature drying, air-drying and watering, and
under the normal temperature, they will dry well indoor.
4. Equipment Model and Product Specification
Technical Index for finished board | 1. Oxygenic index%: 90 2. Level combustion: SO 3. Vertical combustion: SO 4. Water content rate: 10.9% 5. Capacity: 1.15g/cm3 6. Static bending intensity: 169.46Mpa 7. Density: T/ m31.13 8. Water resistance: Without chalking for 24 hours and there is no change on surface 9. No Threewastes (waste water, waste gas and waste residue), no pollution and environmental protection. |
straw Board can be used for ceiling, wall skirting, decorating of
indoor wall and lining board for furniture.It can replace three-ply
board, five-ply board, flakeboard, MDF (Medium Density Fiberboard )
and Gypsum Board.
5. After-sale
After purchased the equipment, our company will take responsibility
for trainning
technical personnel until he can get the skill.
There are many professional technical personnel in our company,
they will offer
consultation about the equipment and technology as well as
technical training on
site for free. And they will go to your factory for installation
and testing for free.
Welcome you to our company for a site visit, we will service for
you sincerely.
